Hair braiding styles — not such simple piece: before at you it will turn out as on the picture, it is required to get the hand thoroughly. However, the award will turn out really royal — you will forever forget about doubts about laying on any action. After all hair dresses from braids (you will be able to look at a photo below) always draw attention, especially if they are made with the imagination.Hair Braiding styles of hairstyles for women— it not only parade of ideas for average and long hair, but also quite available designs. Roughly speaking, it won’t be necessary to cause on the house of the hairdresser because you can independently master weaving of braids. Especially these ideas will be useful to mothers: they know that weaving of braids to girls — difficult business. However, if while you aren’t going to bother with a hair dress, be all the same run by eyes below – at least to understand that modern braids on long hair very much differ from that we once saw on old pictures.
In principle, to learn to do braids to itself – it is easy. It is necessary to get acquainted with lessons of weaving which, fortunately, there is a lot of only. For your convenience we collected in this article of the scheme of weaving of fashionable braids, including even video (weaving of braids demands the full picture because not all photos give an idea how it is made). Are ready to be charged that they will help out you more than once!
Lesson first – a crown
If you already know how to braid a braid, for certain, were interested in how it is original to lay it. Here one of options.
That is required: brush, hairbrush with a thin tip, a bottle with a spray, 2 thin elastic bands for hair, a varnish — at will.
1 . Comb hair and be convinced that on them there are no small knots, and ringlets lie exactly.
2 . Separate part of hair on the center (move from the top, around) and fix them an elastic band (the elastic band is thinner, the accurater the hairdress turns out). It will be part A.
3 . As a result you still have to have “rim” of hair about 5 cm wide. It will be part B.
4 . Hair of part A collect in a horse tail and allow them to fall freely. If any locks overhang on the person — don’t clean them.
5 . Take locks from the left ear from part B and start spinning from them the French braid. When you will set hair atop, take a lock from part A. During weaving of the bottom party add hair from part B. Try that the braid laid down accurately along border between parts — it will help to hide it visually.
6 . Continue weaving as in a step No. 5, stacking a braid along the head, you won’t reach yet the braid basis.
7 . The remained hair weave into the simple spit and fix an elastic band.
8 . Now take a tip of a simple braid and get it in a crown to hide. Be convinced that the braid strong keeps. If all of you made correctly, there will be a feeling of a hairdress at which isn’t present the end, began.
9 . Tips of the French braid record invisible beings.
Braiding video lesson
Lesson second — a volume braid
Weaving of braids on long hair demands some patience, however it is a hundredfold rewarded. Owners of such braid constantly hear compliments.
1. Comb hair. Comb locks in that party where there will be a braid (on video hair are combed back, but the lateral volume braid too looks fine).
2. Take all hair and divide them into three locks. Make first “stitch” of a usual braid.
3. After the first interlacing, at the edges it is necessary to release locks (take the most distant lock at the left, remove part of hair from above and shift them forward. If you do a plait to someone, take a hairpin, ask model to hold locks or take a tip of hair teeth). That it turned out more beautiful, take wider locks at the basis and narrower — closer to the end of a tail.
4. Now lay a lateral lock in the center, continuing to do a classical plait.
5. Repeat a step No. 3 then lay the remained lock in the center with an extreme right lock.
6. Repeat weaving with release of locks, alternating the right and left side until hair end.
7. Fix a design an elastic band. On each side from a braid you still will have symmetric free locks.
8. Now take two free spin at the left (from the top) and one — on the right (too top).
9. Start doing from them the Danish plait. When it is required to add new locks, use the remained free hair on both sides of the classical spit.
10. Finish weaving, as in a usual braid (last 2-3 “stitches”).
11. Then remove an elastic band from the first braid and record it the ends of both turned-out braids.
12. In a ready design of a braid have to lie one over another.
13. To make the Danish braid of more nice, you can stretch slightly lateral locks (especially lower). So the hairdress will look even more volume.
Lesson third — Unusual “falls”
If on long hair you while managed weaving of hair braiding styles, this lesson will help you to cope with a task.
1. Take a small lock from the center of a forehead and divide it into three parts.
2. Start doing a usual plait, make one “stitch”.
3. Now add a few hair only to the top lock (a secret here that, unlike the French and Danish braids, hair are added not to both locks but only to one).
4. As soon as you put hair, bind the increased lock with average.
5. After you crossed locks, clean from increased a few hair and direct them down. So you let out falls “stream”.
6. Continue to add hair to the top lock and to diminish them after cross it to average. Move along a head circle.
7. When you appear at an opposite ear, you dopletit a braid on classical manners and fix the end an elastic band.
Lesson fourth of Hair braiding styles — return “cone”
Everything whom weaving of braids on average hair or on long ringlets at least once interested, know that usual “cone” has a V-shaped form. And our original “cone” will be developed in the opposite direction, than, undoubtedly, will draw to you attention.
That is required: brush, hairbrush with a thin tip, a bottle with a spray, 1 thin elastic band for hair, 1 wide elastic band for hair, a varnish, hairpins — at will.
1 . At first it is necessary to comb all hair in a high horse tail or there, our “cone” will begin from where. To fix a wide elastic band for hair (before collecting hair, they can be sprayed water that the tail looked smooth).
2 . Divide a tail into 2 equal parts.
3 . Take a small lock from outer side of the right part, carry out under the right half. In the same time take a small lock from outer side of the left part, carry out under the left half and cross to the right lock (in usual “cone” of a lock are carried out over tail halves).
4 . Repeat a step No. 3 until hair will end.
5 . The end of a braid fix a thin elastic band.
6 . Stretch lateral locks in the parties thanks to what the braid becomes more volume
7 . If you want, fix over a thin elastic band a hairpin.